Klimaatregelaar voor serres | Ventilatie en verwarming | 3 A

€ 234,40
Verzenden
00sinds 10 jan. '25, 08:41
Deel via
of

Beschrijving

The GTEE1 fan speed controller controls the speed of voltage-controllable, single-phase motors (230 VAC / 50—60 Hz, Imax 3 A) based on the measured temperature. As long as the measured temperature has not reached the set point, the heating element is switched on and the fan runs at the set minimum speed. Once the set point is reached, the heating element switches off. Finally, the speed increases as the set temperature is exceeded. The built-in relay can be used to switch single-phase, electric heating elements of up to 16 A (3.6 kW). Even higher heating elements can be switched by using auxiliary relays.


Pre-wired and ready to use!
This AC fan controller is 100% 'plug & play'. You simply plug it into a wall socket and no configuration or wiring is required. The PT500 temperature probe (4m cable length) and the power cable (1.5m length) are pre-wired. The exhaust fan and the electric heater can be connected via the Schuko socket. Operation
Once the measured temperature exceeds the set temperature, the speed controller will run both the supply and exhaust fans at full speed until the room temperature drops below the set value. Then the fans return to their idle speed. Ideally, the exhaust fan should be larger and run at a higher speed than the supply fan. This way a constant negative pressure is created. This prevents odours or potentially harmful organisms from escaping from any cracks or openings in the grow room or quarantine room before they can be filtered. The desired temperature can be set between 21 and 35 degrees Celsius.No configuration required
The two built-in potentiometers allow you to set the temperature and adjust the minimum and maximum motor speed. The temperature setpoint can be set within the range of 21 - 35 °C. The minimum motor speed (motor voltage) can be set within the range of 80 - 160 VAC. The maximum motor speed (motor voltage) can be set between 180 and 230 VAC.

Quality housing
This controller is the result of innovative electronic technology and many years of experience in temperature treatment in grow rooms. This device is extremely reliable and safe. The housing is made of high-quality r-ABS VO (UL94) plastic. And this material is flame-retardant in case of fire. It is very sturdy and offers good protection against shocks. The housing offers IP54 protection against the ingress of dust, dirt and water. However, to ensure an optimal lifespan, it should be installed in a place where there is no direct sunlight. This fan controller is suitable for wall mounting.

Triac Fan Speed Control
This fan speed controller uses Triac technology to control the fan speed. Fan speed controllers with Triac technology control the motor continuously. The phase angle control of the Triacs ensures that the fan speed controller works completely silently. The disadvantage is that the motor may make some noise at low speeds. This is because the alternating voltage of the motor does not have a perfect sinusoidal shape. To prevent motor noise, the minimum motor voltage can be increased.

Zoekertjesnummer: a146189230